October 11, 2016
How to Recover BMW E84 FRM by Ncs Expert
First try:Then I opened Xprog m programmer and selected com11 and tried to do a read of a Atmel AT93C66 Serial EEprom like all the vidoes (without sound ofc..) is doing as I assumed it’s reading a test ecu or smt inside the xprog. It failed and said bad conenction on pin XXXX. Maybe my assumption wrong so that I actually have to conenct this AT93C66 to the xprog to do the test. I’m not sure. If so I’ll just test it with the MCU but I didn’t want him to drive all the way to my place just to find out that I didn’t have a working install of Xprog..
It’s an awesome guide that is a walk in the park. Helpful to those want torecover/resurrect BMW FRM model.
Model:BMW E84
ZB number:9230450
Car condition:
The car has a 5year/125k miles warranty here. This car had 126k miles and 5 years and a couple of months now that the high pressure diesel pump and FMR module failed in the same month. Was horrible timing to break down on the road.
Tool solution (Xprog):
Got theXprog-mbox ecu programmer and I installed it with installing adobe, using the .reg file to mod the register and then I moved the xprog into C: drive and plugged in the module. I manually selected the win xp32bit drivers and it installed 2x drivers.
First try:Then I opened Xprog m programmer and selected com11 and tried to do a read of a Atmel AT93C66 Serial EEprom like all the vidoes (without sound ofc..) is doing as I assumed it’s reading a test ecu or smt inside the xprog. It failed and said bad conenction on pin XXXX. Maybe my assumption wrong so that I actually have to conenct this AT93C66 to the xprog to do the test. I’m not sure. If so I’ll just test it with the MCU but I didn’t want him to drive all the way to my place just to find out that I didn’t have a working install of Xprog..
Final try- SUCCESS!Connected the Xprog-m and it worked at first try to read out p-data. EEPROM was corrupt so it didn’t read out. Used a FRM .bin file from the first post and flashed EEPROM and p-data, did a readout and used beyond compare to compare the readout with the file I flashed and it was identical. Installed it in the car and had a few error messages but it lighted up and things started working again. I went into Winkfp hit update zusb, input the VIN and flashed. OpenedNcs expertsoftware in expert mode, opened CAS to get vo/vin and hit "back†button to select NFRM and executed sg_codieren to code it with vo/vin. No errors and everything worked afterwards.
Hopefully, it helps someone.
Posted by: jean at
01:37 AM
| No Comments
| Add Comment
Post contains 363 words, total size 3 kb.
21kb generated in CPU 0.0205, elapsed 0.2503 seconds.
35 queries taking 0.2379 seconds, 170 records returned.
Powered by Minx 1.1.6c-pink.
35 queries taking 0.2379 seconds, 170 records returned.
Powered by Minx 1.1.6c-pink.