June 21, 2023
How to Configure Super ICOM Pro N3+ WiFi and USB?
Super ICOM Pro N3+diagnostic tool supports USB and WiFi connection.
How to connectSuper ICOM Pro N3+ via USB?
First time use the device requires to set up IP address.
1. Connect N3+ with power supply or power by OBD from car
2. Connect N3+ with laptop with USB
3. Go to Network Connection, find out Realtek USB FE Family Controller network
4. Click on Properties-TCP/IPV4
Set
IP address to 169.254.90.90,
Subnet mask: 255.255.0.0,
Preferred DNS: 169.254.255.1, click "OK”
Note: Each N3+ is bound to 1 PC. If change another N3+, need to reset IP. After disconnecting the USB cable, the network icon will disappear, and you don’t need to set the IP address again when you use the N3+ after the computer is wired or wirelessly connected to the Internet.
Then run ITool Radar, you will see ICOM device is connected.
How to connectSuper ICOM Pro N3+via WiFi?
N3+ supports WiFi direct connection which is very easy. You have to disconnect USB cable before connecting with WiFi.
Search for WiFi name "N3+ ICOM-****" and pair with password 12345689.
Posted by: jean at
07:25 AM
| No Comments
| Add Comment
Post contains 188 words, total size 7 kb.
25kb generated in CPU 0.0108, elapsed 0.1427 seconds.
35 queries taking 0.1351 seconds, 171 records returned.
Powered by Minx 1.1.6c-pink.
35 queries taking 0.1351 seconds, 171 records returned.
Powered by Minx 1.1.6c-pink.
