TheOBDSTAR 30 pin cableallows us to make Toyota 4A and 8A-BA proximity without pin code. So we don’t need to pay for the pin code from 3d party. It is not only compatible with OBDSTAR tools, but alsoAutel MaxiIM IM508/IM608series.

For example:

This is a 2023 BZ4X electric model with 8A-BA proximity and new TMLF19 Toyota smart box. Here shows how to add a spare key using IM508+ OBDSTAR 30 pin cable.

Left: factory key, right: New key

Autel has some instructions in the tool basically use the G-box and tap into CAN high and CAN Low in plug.

There are also a couple of ways to do without 30 pin cable (Gboxsolution/other solution 1).

But 30 pin cable make it much easier.

Pops off this panel on the little side.
There is really only one 10 millimeter screw holding that panel.
We are going to use little30 pin cable.
Pop airbag out. airbag drops out 30 pin plug.
Under the layout that is the 30 pin plug.
Connect 30 pin cable to 30pin plug and the other end from the car.
That’s all this thing is doing.

After connect 30 pin cable, go to im508 IMMo function, auto detect, it reads VIN and picked it up as a 2023 BZ4X.

Select Control Unit->Keyless System (CAN)

Select Backup IMMO Data

The function is used to back up eeprom data of the smart box which can be used to perform IMMO related functions without PIN.

Generally speaking we gotta we should be shutting the ignition off while we’re reading that data

Read and then save IMMO data

Select Add key function

1. PIN verification
2. Key learning

Upload immo data just read to read PIN

If failed to read PIN, try several times until succeed

Then add smart key

Add smart key successfully, test the new key.

Take the battery out of remote make sure the emergency start works as well.

That’s it 2023 year model, 2024 is no different andAutel im508can handle the 24 no problem.

Posted by: jean at 06:09 AM | No Comments | Add Comment
Post contains 346 words, total size 16 kb.