You cannot use Vediamo 5 withTactrix openport 2.0because 5 does not support passthru so you need to install Vediamo 4 with openport (CheckOpenport Xentry Pros & Cons).

Here are the tips on installing and configuring Vediamo withOpenPort 2.0+ trendy Agility mode.

Found on the Internet theVediamo v04.02.02.andVediamo Data files(password for archives 123).It is in this version of Vediamo that Part J is supported, i.e.the ability to connect PassThru devices.

To do this, change the device name (DeviceName) in the slave.ini file (C:\Program Files\Vediamo\Caesar\drivers).Since I already have drivers for OpenPort 2.0 on my laptop and the DAS Xentry program is installed, I just followed the path (C:\ProgramData\Mercedes-Benz\config\Xentry\caesar\driver\slave.ini) and copied from the file slave.ini section "J” data.It turned out like this: DeviceName="Tactrix Inc. – OpenPort 2.0 J2534 ISO/CAN/VPW/PWM”

After that, on the Vediamo server tab, I pressed UPDATE, unchecked all the checkboxes and left only a checkmark in front of point J.

After all the manipulations, the Vediamo program saw OpenPort 2.0, but refused to connect to the car.It turns out that by default I have the KLine connection type in the Vediamo settings, so I did this: I went toEcoute, selected theEGS52.CBFfile I needed from the Vediamo Data folder, then right-clicked on the line displaying the EGS52-<basisvariante> (KLine 1 OpenPort 2.0 J2534, etc.), clicked on the properties item andchanged the connection type from KLine 1 to CANHS1and got the lineEGS52-<basisvariante>(CANHS 1 OpenPort 2.0 J2534, etc.) .

Kline

CANHS

After that, Vediamo connected to the car without any problems and I read my encoding.

http://blog.obdii365.com/2022/07/20/configure-vediamo-with-openport-2-0/

Posted by: jean at 07:00 AM | No Comments | Add Comment
Post contains 263 words, total size 7 kb.