BMW F10 528i 2013 Used TCM Programming by CGDI BMW

Here's the instruction on BMW F10 528i 2013 used TCM (EGS) programming after replacement. Reset ISN withCGDI Prog BMW, tried flashing with E-sys but got some troubles, programming and encoding on car done by cgdi bmw and error check with ista+.

 

Part 1: Reset ISN on bench

Connect CGDI BMW with EGS 8HP (Check wiring diagram and detail guidehere)

In CGDI BMW software, go toBMW EGS change-8HP (F)-Clear ISN

 

 

Confirm VIN

 

EGS ISN is cleared
that was the first part, done on bench.

 

 

Part 2:
The second part when trying to flash TCU, i got some troubles withe-sys, reported a PSD2 error.

 

 

Part 3: Programming TCU

Finally, i finish programming and encoding bycgdi bmwon car

 

 

Go toDiagnosis, Program and Coding-BMW E/F Series Program

 

 

Select EGS SWFL desired to program, and pressAdvanced programming
CGDI will ask to keep car battery enough power and device cabled connected during the programming procedure

 

select file version and confirm
input 17-digit VIN and confirm

 

 

program ECU in progress

 

 

 

Program and flash tcu successfully.

check and erase fault codes withBMW ICOM ISTA+

 

http://blog.obdii365.com/2022/01/25/bmw-f10-used-tcm-programming-with-cgdi-bmw/

Posted by: jean at 06:18 AM | No Comments | Add Comment
Post contains 187 words, total size 11 kb.