In order to code the DMB driving lock in the E series, I added the parameters and modified the data value to FF, so I added the parameters many times, so I applied the additional method.

When replacing a battery with an amp that is higher than the original amp, sometimes I need to add a parameter to set the proper ampere .... I do not have to .... But, I want to ....

I can not see the 100 amperes parameter in BMW coding softwareNCS Dummy.

first

If you search for KLASSE_BATTERIE to set the battery

(First picture) KLASSE_BATTERIE - Select BATTERY TYPE, right click on it and select Add parameter to modify the added parameters .... (second, third picture)

Edit the data (fourth picture) .... The modification here seems to be the menu order. 01, 02, 03, ....... 09,0A.0B, 0C.0D, ......

In the DMB lock, I modified the setting value to FF ..... It seems that the order is not so important here. So it makes sense that some people do not need to set it up.

I think the battery should be reset.

Finally (in the fifth figure), press the Module Functions button to select the Update Module.

When you start to update the module, you will be notified that you can not revert anymore.

Now go back and load the modified module and you will see the modified 100 amperes.

I have added two parameters: 100 amps in general and 100 amps in AGM batteries.

BMW ICOM ISTA-D ISTA-P with engineering software INPA Ncs expert, WInKFP

Note: The document was translated from Korean. Credit tods5ppx.

www.obdii365.com

Posted by: jean at 06:52 AM | No Comments | Add Comment
Post contains 277 words, total size 5 kb.