If you’re working on a 2024, 2025, or 2026 Toyota Corolla Cross and need to read immobilizer data or erase keys without adding a new key, you may need to access the vehicle’s bypass connector.

Where to find the bypass location on this model. The process is straightforward and requires no special tools.

Step-by-Step Instructions:

1. Open the glove box– Start by opening the passenger side glove box.

2. Release the latches– There are two latches holding the glove box in place. Release them both.

3. Drop the glove box down– Once the latches are undone, lower the glove box completely to access the area behind it.

4. Locate the top plug– Behind the glove box, you will see a series of connectors. The one you need is thetop white connector.

5. Connect the bypass (Toyota 30 pin cable)– Remove the top plug and connect your bypass module to this port.

This method allows you to read the necessary data and erase keys without needing to add a new key. Once the bypass is connected, you can complete the job as usual.

Quick Tip:
Make sure the vehicle is a 2024–2026 Toyota Corolla Cross, as the connector location may vary on other models or years.

Posted by: jean at 07:15 AM | No Comments | Add Comment
Post contains 209 words, total size 6 kb.